Description
Applications
Surface Preparation
The maximum performance of Tectyl™ 502-C cutbacks can be
achieved only when the metal surfaces to be protected are clean, dry
and free of rust, oil and mill scale. CorPro recommends that the metal
substrate temperature is 10-35 °C at the time of product application.
Direct contact of Tectyl™ 502-C with PVC can cause compatibility
problems. Please test prior to use.
Application
Tectyl™ 502-C is formulated to be used as supplied. CorPro
recommends that the ambient and product temperature be 10-35 °C
at the time of product application. Do not thin Tectyl™ 502-C.
Incorrect thinning will affect film build, dry time and product
performance. Tectyl™ 502-C can be applied by low pressure air
spray or dipping. Details on application can be found in the
application chart.
Removal
Tectyl™ 502-C can in the wet phase be removed with Tectyl™
Biocleaner, Tectyl™ 150 or low-pressure steam. If dried and
cured the film of Tectyl™ 502-C can be removed with Tectyl™
Biocleaner or Tectyl™ 150. When applied in a gearbox or
similar application, Tectyl™ 502-C does not need to be removed
and will dissolve in the oil.
Features & Benefits
Superior Protection
At the recommended DFT Tectyl™ 502-C will protect against
corrosion during storage, domestic and overseas transport.
Processing
Tectyl™ 502-C is easy to apply and easy to remove, when no
longer needed.
Economical
With a DFT of only 50 microns, Tectyl™ 502-C can protect a big
surface with just little amount of the product