Description
Surface Preparation
The maximum performance of Tectyl™ Underbody Coating
Bronze can be achieved only when the metal surfaces to be protected
are clean, dry and free of rust, oil and mill scale. CorPro recommends
a substrate temperature of 10-35 °C at the time of product
application. Avoid direct contact of the product with PVC due to
possible material incompatibility.
Application
Tectyl™ Underbody Coating Bronze gives a maximum
performance when it is sprayed at an ambient and product
temperature of 10-25 °C. Shake the can well before use and spray at
a distance of approximately 30 cm from the surface.
Tectyl™ Underbody Coating Bronze is fast-drying, and this can
cause ‘pin-holing’ when applied too thick at once. It is advised to
spray one layer per pass, wait for 2 to 3 minutes and then spray
another layer. Continue like this until the required film thickness has
been obtained.
Removal
Tectyl™ Underbody Coating Bronze can be removed in the wet
phase with Tectyl™ Biocleaner, Tectyl™ 150 or low-pressure
steam. If dried and cured Tectyl™ Underbody Coating Bronze
can be removed with Tectyl™ Biocleaner or Tectyl™ 150.
